Page Comparison

...

In order to manage activation of heating or cooling within location, use predefined virtual multi-value switch Mode.

Image Modified	Image Modified	Image Modified	Image Modified
Winter	Summer	Spring, Autumn	Spring / Autumn

To adjust Mode switch to show only modes that are relevant for specific location, use Service Settings of Mode multi-value switch.
In Service Settings, open DEVICE tab and turn on/off specific modes.

...

Partial support for Mode is also in:

...

HOT (increasing temperature when output actuator is open) or
COLD (decreasing temperature if output actuator is open)
DYNAMIC (output actuator is controlling system that can produce both HOT and COLD)

Table below shows behaviour of hysteresis and PID smart rules based on type of Medium and value of Mode switch:

Output actuator is turned on

	Medium: HOT	Medium: COLD
Heating Mode

Hysteresis controller enabled
PID controller enabled

Output actuator turns ON when
desired temperature is higher than actual temperature

Hysteresis controller disabled

PID controller disabled

Cooling Mode
Output actuator is held in OFF state regardless of temperature

Hysteresis controller disabled

PID controller disabled

Output actuator is held in OFF state
regardless of temperature

Hysteresis controller enabled

PID controller enabled

Heating & Cooling Mode
	Output actuator is turned on when desired temperature is lower than actual temperature

Hysteresis controller enabled

PID controller enabled

Output actuator is turned on when
desired temperature is higher than actual temperature

Hysteresis controller enabled

PID controller enabled

Off (No heating, no cooling)
Output actuator is turned on when desired temperature is lower than actual temperature

Hysteresis controller disabled

PID controller disabled

Output actuator is held in OFF state
regardless of temperature

Hysteresis controller disabled

PID controller disabled

Output actuator is held in OFF state
regardless of temperature

...

Versions Compared