To create fully working thermostat you will need two Input sensors (air and floor one), an Output actuator, virtual Thermostat device and Hysteresis Smart Rule
- To create Input sensors go to module where physical temperature sensors are located and enable them (usually NTC, UI or Core module).
|
|
|---|
2. To create an Output actuator, go to DO12 module where real output is located and enable relevant this output as "Switch". This output relay will control related heating element.
|
|
|
|---|
3. To create Virtual Thermostat, go to Settings → Virtual devices → Add device → Thermostat
|
|
|---|
4. Open Thermostat Servise settings and define Air and Floor Sensors enabled in Step 1.
|
|
|---|
5. Add Smart Rule Temperature hysteresis controller with following settings
- Mode = Heating fixed (there are more option options explained here Heating and Cooling modes
- Medium = Hot (fixed) Range = oscilation range +/- value, default value 0.5 Degrees, Output device = Output actuator, Limit temperature + Lmit temperature Sensor = usually floor temperature sensor with the limit temperature value
|
|
|
|---|
6. Final result
