Page Comparison

Smart rules for regulation of temperature control have unified setting for switching between heating and cooling modes.

Define which modes are supported

...

In order to manage activation of heating or cooling within location, use predefined virtual multi-value switch Mode.

...

1. To adjust Mode switch to show only modes that are relevant for specific location, use Service Settings of Mode multi-value switch.
   
2. In Service Settings, open DEVICE tab and turn on/off specific modes.

...

Partial support for Mode is also in:

• Equithermic Equitherm regulation
• Blinds adjustment according to sun

...

	Medium: HOT	Medium: COLD
Heating Mode	Output actuator turns ON when desired temperature is higher than actual temperature	Output actuator is held in OFF state regardless of temperature
Cooling Mode	Output actuator is held in OFF state regardless of temperature	Output actuator is turned on when desired temperature is lower than actual temperature
Heating & Cooling Mode	Output actuator is turned on when desired temperature is higher than actual temperature	Output actuator is turned on when desired temperature is lower than actual temperature
Off (No heating, no cooling)	Output actuator is held in OFF state regardless of temperature	Output actuator is held in OFF state regardless of temperature

Example

Zone regulation of floor heating with hot water from boiler

Simple setup: Hot water is circulating in the pipes during heating season, and there is no circulation during cooling season (managed by boiler).

• Set Mode to "Fixed heating"
• Set Medium to "Hot (fixed)"

Automatic switching of Heating / Cooling modes

In order for the system to automatically switch the modes, add smart rule Equation for the multi-value switch Mode.

Example: