To create fully working thermostat you will need:
- Temperature sensor for air temperature input and if electric floor heating is used, also one for floor temperature
- an Output actuator
- virtual Thermostat device
- Hysteresis Smart Rule
doc_tap_workingthermostatRule;
...
doc_tap_createInputsensors;
|
|
|---|
2. To create an Output actuator, go to an output module where real output is located and enable this output as "Switch". This output relay will control related heating element.
doc_tap_Outputactuator;
|
|
|
|---|
...
doc_tap_VirtualThermostat;
|
|
|---|
...
doc_tap_ThermostatServicesettings;
|
|
|---|
5. Add Smart Rule Temperature hysteresis controller with following settings
- Mode = Heating fixed
- Medium = Hot (fixed)
doc_tap_RuleTemperatureMedium;
(Mode and Medium are explained here Heating and Cooling modes)
doc_tap_ModeMedium;
...
doc_tap_Rangevalue;
|
|
|
|---|
...
doc_tap_Finalres;
