...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
1. Add KNX gateway to TapHome bus doc_tap_
...
knx_gtw;
For adding KNX gateway to TapHome Bus use the same procedure as for any TapHome device. Choose in TapHome Bus - Find new devices - and wait until KNX Gateway is added to bus. Now you can find it in TapHome Bus devices:
doc_tap_add_KNX;
2. Add new interface doc_tap_
...
new;
In Hardware option choose Add new interface and select KNX from the list:
...
In opened list of devices select KNX Gateway (KNXG) and click Next:
doc_tap_select_KNX;
3. Add KNX devices doc_tap
...
_knx_dev;
In KNX interface now click on Add device. In opened supported list of devices choose the device and click OK:
...
Select back and save parameters. Now the device is configured and data should be updated from/to KNX bus.
doc_tap_knx_bus;
4. Devices with multiple datapoints doc_tap
...
_mult_data;
4.1 Thermostat doc_tap_41_therm;
Opening Thermostat definition will show following data points:
doc_tap_op_therm;
If there is no humidity measurement include in device set this to 0 - Disabled
doc_tap_hum_meas;
4.2 Blind doc_tap_42_bl;
Opening Blind definition will show following data points:
doc_tap_op_blind;
4.3 Push button doc_tap_43_button;
Besides using classic push buttons, TapHome also works with design KNX push buttons.
doc_tap_knx_pushb;
In the description below, the configuration enables all the precise control options as they are usual in TapHome:
- Light switching
- Scene sequencer
- Blinds control with different responses to short press and long press
- Continuous dimming while the push button is held
doc_tap_price_co;
Set Channel function to Dimming:
doc_tap_set_ChFu;
Two data point types are generated - switching and dimming.
doc_tap_swit_dim;
Define 1 Bit data point type for Short press and 4 Bit data point type for Long press:
doc_tap_Short_long_p;
Create Group Addresses for both Short press and Long press and link the devices:
doc_tap_adresa;
In TapHome, map both Short press and Long press:
doc_tap_obidve;
