Page Comparison

Smart rules for temperature control have unified setting for switching between heating and cooling modes.

doc_tap_

...

Define which modes are supported

doc_tap_Dms;

...

Dms;

doc_tap_Mswitch;
Image Modified

...

doc_tap_ServiceSmodes;

Image Modified

Image Modified

Image Modified

Image Modified

Winter SummerSpring, AutumnSpring / Autumn

doc_tap_Winter;

doc_tap_Summer;

doc_tap_SpringAut;

doc_tap_SprAutumn;

Set behaviour of heating / cooling smart rules based on Mode value

doc_tap_behaviour;

Mode is supported in smart rules:

...

doc_tap_Modecontroller;

Image Removed

Partial support for Mode is also in:

...

doc_tap_Modesun;

...

doc_tap_Mediumactuator;

...

Medium is e.g. water running in pipes, and you can select between 2 types plus dynamic switching based on reed contact or switch device:

...

...

doc_tap_MediumCOLD;

...

Table below shows behaviour of hysteresis and PID smart rules based on type of Medium and value of Mode switch:

doc_tap_Tableswitch;

Medium:
HOT

Medium:
COLD

doc_tap_MHOT;	doc_tap_MCOLD;

HeatingMode

Output actuator turns ON when
desired temperature is higher than actual temperature

Output actuator is held in OFF state
regardless of temperature

doc_tap_HeaM;

doc

doc_tap_

ONhigher

ONhigher;

doc

doc_tap_OFFstatet;

Cooling
Mode

Output actuator is held in OFF state
regardless of temperature

Output actuator is turned on when
desired temperature is lower than actual temperature

doc_tap_CoolMo;	doc_tap_OFFstatetemper;	doc_tap_ Outputactuatorlow;

Heating
& Cooling
Mode

Output actuator is turned on when
desired temperature is higher than actual temperature

Output actuator is turned on when
desired temperature is lower than actual temperature

doc_tap_HCMod;	doc_tap_ Outputahigher;	doc_tap_ Outputaclower;

Off
(No heating,
no cooling)

Output actuator is held in OFF state
regardless of temperature

Output actuator is held in OFF state
regardless of temperature

doc_tap_Noheat;

doc

doc_tap_oaoffs;

doc

doc_tap_oaoffstate;

Example

doc_tap_Ex;

...

doc_tap_ Zoneboiler;

...

Simple setup: Hot water is circulating in the pipes during heating season, and there is no circulation during cooling season (managed by boiler).

...

...

doc_tap_ Simplefixed;

Automatic switching of Heating / Cooling modes

doc_tap_ AutomaticHC;

...

In order for the system to automatically switch the modes, add smart rule Equation for the multi-value switch Mode.

...

doc_tap_EquationMode;

Image Removed

...

doc_tap_Dynamicw;

...

If you use a machine (e.g. heat pump) that is able to produce both heating and cooling medium via the same output actuator, Dynamic type of medium is required for proper configuration. 

There are two possible scenario:

...

...

doc_tap_IfCooling;

Image Removed

Image Added

Image Removed

Image Removed

...

	Image Added		Image Added

doc_tap_Thermostatstep;

Image Removed

Image Added

Image Removed

Image Removed

2. Heat pump is in manual mode and the TapHome switches between hot and cold using output relays that control auxillary inputs on heat pump.

...

	Image Added		Image Added

doc_tap_Heatpump_settings;

Image Removed

Image Added

Image Removed

...

	Image Added

doc_tap_CreateGostep;

Image Removed

Image Added

Image Removed

	Image Added

Image Removed

	Image Added