In order to get notified when temperature exceeds certain value, or any other condition is met, use the setup scenario below.
Send notification when temperature exceeds 25 degrees
...
doc_tap_notified;
doc_tap_notification25deg;
Set name "Notification"
...
Set smart rule Equation to turn on your virtual emergency switch if the notification condition is met.
In our example, we are checking if one of temperatures (Temperature 1, Temperature 2) is higher than 25ºC. Also, once this condition is met, we set minimum duration to 30 minutes, so that we don't receive notifications too often.
...
Variables
Temperature 1
Temperature 2
doc_tap_Create_Emerg;
doc_tap_SettingEmerg;
doc_tap_Opendetails;
doc_tap_ruleEquation;
doc_tap_EquationOften;
...
Send notifications when these sensors change:
Notification
+ Add sensor
...
Notifications
Notify if turned on
Message: Temperatures higher than 25ºC
Notify if turned off
Message: Temperatures are OK
| doc_tap_Equation; | doc_tap_Ren1; |
| doc_tap_sett_cond1; | |
doc_tap_VTT12; | Te = 21.8ºC |
...
Equation
(Te > 25) or (Te1 > 25)
...
Actions
If result is TRUE, perform following actions:
Notification
On
...
If result is FALSE, perform following actions:
Notification
Off
...
Duration
When to stop performing specified actions
Minimum duration
Value: 30 minutes
Maximum duration
Value: not set
...
...
Set smart rule Notification to provide proper feedback when temperatures are higher than 25 degrees:
doc_tap_EquationTe; | |
doc_tap_ActNotific; | doc_tap_ActOn; |
doc_tap_Falsenotif; | doc_tap_FalseOff; |
doc_tap_Duration30min; |
|
doc_tap_OpenNotif;
doc_tap_SetNotif;
| doc_tap_Notific; | doc_tap_Ren2; |
| doc_tap_sett_cond2; | |
doc_tap_NotifictSensor; | |
doc_tap_NotificTempr25ºC; |
|
| Info |
|---|
There are more ways to setup push notifications: doc_tap_DeviceSimpleAlarm; |