Page Comparison

Smart rules for regulation of temperature have unified setting for switching between heating and cooling modes.

Define which modes are supported in your location

...

doc_tap_Dms;

doc_tap_Mswitch;
Image Added

doc_tap_ServiceSmodes;

Image Modified	Image Modified	Image Modified	Image Modified
doc_tap_Winter;	doc_tap_Summer

Spring, AutumnSpring / Autumn

To adjust Mode switch to show only modes that are relevant for specific location, use Service Settings of Mode multi-value switch.
Image Removed
In Service Settings, open DEVICE tab and turn on/off specific modes.

Info
If you want to set different modes for every zone (or section of the house), you can define multiple Mode virtual switches. Go to Settings → Virtual devices → Add virtual device → Multi-Value Switch section: Heating & Cooling.

Set behaviour of heating / cooling smart rules based on Mode value

Mode is supported in smart rules:

Temperature hysteresis controller
Temperature PID controller

Image Removed

Partial support for Mode is also in:

Equithermic regulation
Blinds adjustment according to sun

Type of Medium that is controlled by output actuator

Medium is e.g. water running in pipes, and you can select between 2 types plus dynamic switching based on reed contact or switch device:

HOT (increasing temperature when output actuator is open) or
COLD (decreasing temperature if output actuator is open)
DYNAMIC

Table below shows behaviour of hysteresis and PID smart rules based on type of Medium and value of Mode switch:

...

Hysteresis controller enabled
PID controller enabled

Output actuator is turned on when
desired temperature is higher than actual temperature

...

Hysteresis controller disabled
PID controller disabled

Output actuator is held in OFF state
regardless of temperature

...

Hysteresis controller disabled
PID controller disabled

Output actuator is held in OFF state
regardless of temperature

...

Output actuator is turned on when
desired temperature is lower than actual temperature

...

Hysteresis controller enabled
PID controller enabled

Output actuator is turned on when
desired temperature is higher than actual temperature

...

Output actuator is turned on when
desired temperature is lower than actual temperature

...

Hysteresis controller disabled
PID controller disabled

Output actuator is held in OFF state
regardless of temperature

...

Hysteresis controller disabled
PID controller disabled

Output actuator is held in OFF state
regardless of temperature

doc_tap_behaviour;

doc_tap_Modecontroller;

...

doc_tap_Modesun;

doc_tap_Mediumactuator;

doc_tap_MediumCOLD;

doc_tap_Tableswitch;

	doc_tap_MHOT;	doc_tap_MCOLD;
doc_tap_HeaM;	doc_tap_ONhigher;	doc_tap_OFFstatet;
doc_tap_CoolMo;	doc_tap_OFFstatetemper;	doc_tap_ Outputactuatorlow;
doc_tap_HCMod;	doc_tap_ Outputahigher;	doc_tap_ Outputaclower;
doc_tap_Noheat;	doc_tap_oaoffs;	doc_tap_oaoffstate;