Page Comparison

To create fully working thermostat you will need two Input sensors (air and floor one), an Output actuator, virtual Thermostat device and Hysteresis Smart Rule

1. To create Input sensors go to module where physical temperature sensors are located and enable them (usually NTC, UI or Core module).

...

...

...

doc_tap_workingthermostatRule;

doc_tap_createInputsensors;

doc_tap_Outputactuator;

3. To create Virtual Thermostat, go to Settings → Virtual devices → Add device → Thermostatdoc_tap_VirtualThermostat;

4. Open Thermostat Servise settings and define Air and Floor Sensors enabled in Step 1.doc_tap_ThermostatServicesettings;

5. Add Smart Rule Temperature hysteresis controller with following settings

...

doc_tap_RuleTemperatureMedium; 

doc_tap_MHCmodes;

doc_tap_Rangevalue;

6. Final resultdoc_tap_Finalres;