...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
1.
...
doc_tap_
...
knx_gtw;
...
doc_tap_add_KNX;
2.
...
doc_tap_
...
new;
...
In Hardware option choose Add new interface and select KNX from the list:
doc_tap_hdw_KNX;
In KNX interface click on KNXGatewayId:
In opened list of devices select KNX Gateway (KNXG) and click Next:
doc_tap_select_KNX;
3.
...
doc_tap_
...
knx_
...
devies;
doc_tap_knx_interf_ok;
Now in KNX Interface you will see the added device:
doc_tap_knx_dev;
Click on the device, select Service Settings, click on tab Device and fill the device parameters defined in ETS for KNX BAOS Gateway:
doc_tap_knx_baos_gw;
DTPIndex is the data point number defined, and DTPType is the data point type.
Select back and save parameters. Now the device is configured and data should be updated from/to KNX bus.
doc_tap_knx_bus;
4.
...
doc_tap
...
_mult_data;
...
doc_tap_41_therm;
Opening Thermostat definition will show following data points:
doc_tap_op_therm;
If there is no humidity measurement include in device set this to 0 - Disabled
doc_tap_hum_meas;
...
doc_tap_42_bl;
Opening Blind definition will show following data points:
doc_tap_op_blind;
...
doc_tap_43_button;
...
...
doc_tap_knx_pushb;
In the description below, the configuration enables all the precise control options as they are usual in TapHome:
- Light switching
- Scene sequencer
- Blinds control with different responses to short press and long press
- Continuous dimming while the push button is held
doc_tap_price_co;
Set Channel function to Dimming:
doc_tap_set_ChFu;
Two data point types are generated - switching and dimming.
doc_tap_swit_dim;
Define 1 Bit data point type for Short press and 4 Bit data point type for Long press:
doc_tap_Short_long_p;
Create Group Addresses for both Short press and Long press and link the devices:
doc_tap_adresa;
In TapHome, map both Short press and Long press:
doc_tap_obidve;
