Page Comparison

Smart rules for regulation of temperature have unified setting for switching between heating and cooling modes.

Define which modes are supported in your location

...

doc_tap_Dms;

doc_tap_Mswitch;
Image Added

doc_tap_ServiceSmodes;

Image Modified	Image Modified	Image Modified	Image Modified
doc_tap_Winter;	doc_tap_Summer

Spring, AutumnSpring / Autumn

1. To adjust Mode switch to show only modes that are relevant for specific location, use Service Settings of Mode multi-value switch.
   Image Removed
2. In Service Settings, open DEVICE tab and turn on/off specific modes.

Set behaviour of heating / cooling smart rules based on Mode value

Mode is supported in smart rules:

• Temperature hysteresis controller
• Temperature PID controller

Image Removed

Partial support for Mode is also in:

• Equithermic regulation
• Blinds adjustment according to sun

Type of Medium that is controlled by output actuator

Medium is e.g. water running in pipes, and you can select between 2 types plus dynamic switching based on reed contact or switch device:

• HOT (increasing temperature when output actuator is open) or
• COLD (decreasing temperature if output actuator is open)
• DYNAMIC (output actuator is controlling system that can produce both HOT and COLD)

Table below shows behaviour of hysteresis and PID smart rules based on type of Medium and value of Mode switch:

Medium:
HOTMedium:
COLDHeating
Mode

Output actuator turns ON when
desired temperature is higher than actual temperature

Output actuator is held in OFF state
regardless of temperature

Cooling
Mode

Output actuator is held in OFF state
regardless of temperature

Output actuator is turned on when
desired temperature is lower than actual temperature

Heating
& Cooling
Mode

Output actuator is turned on when
desired temperature is higher than actual temperature

Output actuator is turned on when
desired temperature is lower than actual temperature

Off
(No heating,
no cooling)

Output actuator is held in OFF state
regardless of temperature

Output actuator is held in OFF state
regardless of temperature

;

doc_tap_SpringAut;

doc_tap_SprAutumn;

doc_tap_behaviour;

doc_tap_Modecontroller;

...

doc_tap_Modesun;

doc_tap_Mediumactuator;

doc_tap_MediumCOLD;

doc_tap_Tableswitch;

doc_tap_Ex;

doc_tap_ Zoneboiler;

doc_tap_ Simplefixed;

doc_tap_ AutomaticHC;

doc_tap_EquationMode;

doc_tap_Dynamicw;

doc_tap_IfCooling;

Image Added		Image Added		Image Added

doc_tap_Thermostatstep;

Image Added		Image Added		Image Added

doc_tap_Heatpump_settings;

Image Added		Image Added

doc_tap_CreateGostep;

Image Added		Image Added		Image Added