To create fully working thermostat you will need:
- Temperature sensor for air temperature input and if electric floor heating is used, also one for floor temperature
- an Output actuator
- virtual Thermostat device
- Hysteresis Smart Rule
- To create Input sensors go to module where physical temperature sensors are located and enable them:
|
|
|---|
2. To create an Output actuator, go to an output module where real output is located and enable this output as "Switch". This output relay will control related heating element.
|
|
|
|---|
3. To create Virtual Thermostat, go to Settings → Virtual devices → Add device → Thermostat
|
|
|---|
4. Open Thermostat Service settings and define Air sensor (and a Floor Sensor as well for electric floor heating) enabled in Step 1.
|
|
|---|
5. Add Smart Rule Temperature hysteresis controller with following settings
- Mode = Heating fixed (there are more options explained here Heating and Cooling modes
- Medium = Hot (fixed) Range = oscillation range +/- value, default value 0.5 Degrees, Output device = Output actuator, Limit temperature + Limit temperature Sensor = usually floor temperature sensor with the limit temperature value
|
|
|
|---|
6. Final result
