DC blinds, slides, awnings with Encoder signal

doc_tap_Position_of_DC_blinds;

doc_tap_Service_settings_of_blinds;

doc_tap_Calibration;

doc_tap_Calibration_All_calibration_p;

doc_tap_Calibration;doc_tap_Default_value;
doc_tap_Set_reverse_motor_direction;doc_tap_off;

doc_tap_Encoder_settings;

doc_tap_Calculation_of_position;

doc_tap_Encoder_settings_section; 

doc_tap_Attribute;doc_tap_Default_value;
doc_tap_Max_time;150 ms
doc_tap_Max_time_down;150 ms

doc_tap_Number;

2000

doc_tap_Number_impulses;

doc_tap_not;

103

doc_tap_Number_impulses;

doc_tap_not;

103

Calibration current
Limit of current during calibration.

71%

doc_tap_Calibration;

doc_tap_Limit_calibration; 

71%

Normal operation current 
Limit of current during normal operation up.

83%

doc_tap_Normal;

doc_tap_Limit_operation;

83%

Normal operation current down
Limit of current during normal operation down.

38%

doc_tap_Normal_down;

doc_tap_Limit_down;

38%

Maximal current down change
Prevent reloading blind up in case when it is moving down. Stops blind moving down in case the current down is higher than average current down in defined percent.

250%

doc_tap_Maximal;

doc_tap_Prevent;

250%

Impulses per second to regulate speed. 
Holds constant speed by using the number of impulses per second. If this is not possible to reach it holds higher possible or lower possible speed. To disable speed control set to 0.

0

doc_tap_Impulses;

doc_tap_Holds;

0

Minimal PWM value. 
Set minimal PWM value to regulate blind speed or to use soft start and soft end.

50

doc_tap_Minimal;

doc_tap_set;

50