doc_tap_notified;
Send notification when temperature exceeds 25 degrees
doc_tap_notification25deg;
Create virtual device (Menu → Settings → Virtual devices → + (or Add virtual device) → Switch
Set name "Notification"
Set device type = Emergency:
doc_tap_Create_Emerg;
Setting Emergency device type will automatically pre-define correct icons and names for On and Off states:
doc_tap_SettingEmerg;
Open details of this new virtual switch and select Add a new smart rule
doc_tap_Opendetails;
Select smart rule Equation
doc_tap_ruleEquation;
Set smart rule Equation to turn on your virtual emergency switch if the notification condition is met.
In our example, we are checking if one of temperatures (Temperature 1, Temperature 2) is higher than 25ºC. Also, once this condition is met, we set minimum duration to 30 minutes, so that we don't receive notifications too often.
doc_tap_EquationOften;
| ← Equation | Rename |
| doc_tap_Equation; | doc_tap_Ren1; |
| SETTINGS INFO LIMITING CONDITION | |
| doc_tap_sett_cond1; | |
Variables Temperature 1 | Te = 21.8ºC |
| doc_tap_VTT12; | |
Equation (Te > 25) or (Te1 > 25) | |
| doc_tap_Equation; | |
Actions If result is TRUE, perform following actions: Notification | On |
| doc_tap_ActNotific; | doc_tap_ActOn; |
If result is FALSE, perform following actions: Notification | Off |
| doc_tap_Falsenotif; | doc_tap_FalseOff; |
Duration When to stop performing specified actions Minimum duration Maximum duration |
|
| doc_tap_Duration30min; | doc_tap_(/); doc_tap_(X); |
Open detail of device Notification and add smart rule "Notification"
doc_tap_OpenNotif;
Set smart rule Notification to provide proper feedback when temperatures are higher than 25 degrees:
doc_tap_SetNotif;
| ← Notification | Rename |
| doc_tap_Notific; | doc_tap_Ren2; |
| SETTINGS INFO LIMITING CONDITION | |
| doc_tap_sett_cond2; | |
Send notifications when these sensors change: Notification + Add sensor | |
| doc_tap_NotifictSensor; | |
Notifications Notify if turned on Notify if turned off |
|
| doc_tap_NotificTempr25ºC; | doc_tap_(/); doc_tap_(/); |
There are more ways to setup push notifications:
- Smart rule Device error notification sends notification always when one of specified devices is in error state
- Smart rule Simple alarm sends push notification when there is a motion detected on one of specified sensors. It can be door/window magnet, or motion sensor
- Smart rule Alarm can have push notification defined for each phase doc_tap_DeviceSimpleAlarm;