1. Add KNX gateway to TapHome bus   doc_tap_1knx_gtw;

For adding KNX gateway to TapHome Bus use the same procedure as for any TapHome device. Choose in TapHome Bus - Find new devices - and wait until KNX Gateway is added to bus. Now you can find it in TapHome Bus devices:

doc_tap_add_KNX;

2. Add new interface    doc_tap_2new;

In Hardware option choose Add new interface and select KNX from the list:

doc_tap_hdw_KNX;

In KNX interface click on KNXGatewayId:

In opened list of devices select KNX Gateway (KNXG) and click Next:

doc_tap_select_KNX;

3. Add KNX devices    doc_tap_3_knx_dev;

In KNX interface now click on Add device. In opened supported list of devices choose the device and click OK:

doc_tap_knx_interf_ok;

Now in KNX Interface you will see the added device:

doc_tap_knx_dev;

Click on the device, select Service Settings, click on tab Device and fill the device parameters defined in ETS for KNX BAOS Gateway:

doc_tap_knx_baos_gw;

DTPIndex is the data point number defined, and DTPType is the data point type.

Select back and save parameters. Now the device is configured and data should be updated from/to KNX bus.

doc_tap_knx_bus;

4. Devices with multiple datapoints    doc_tap_4_mult_data;

4.1 Thermostat       doc_tap_41_therm;

Opening Thermostat definition will show following data points:

doc_tap_op_therm;

If there is no humidity measurement include in device set this to 0 - Disabled

doc_tap_hum_meas;

4.2 Blind      doc_tap_42_bl;

Opening Blind definition will show following data points:

doc_tap_op_blind;

4.3 Push button      doc_tap_43_button;

Besides using classic push buttons, TapHome also works with design KNX push buttons.         

doc_tap_knx_pushb;

In the description below, the configuration enables all the precise control options as they are usual in TapHome:

• Light switching
• Scene sequencer
• Blinds control with different responses to short press and long press
• Continuous dimming while the push button is held

doc_tap_price_co;

Set Channel function to Dimming:            

doc_tap_set_ChFu;

Two data point types are generated - switching and dimming.

doc_tap_swit_dim;

Define 1 Bit data point type for Short press and 4 Bit data point type for Long press:

doc_tap_Short_long_p;

Create Group Addresses for both Short press and Long press and link the devices:

doc_tap_adresa;

In TapHome, map both Short press and Long press:

doc_tap_obidve;