The basic setup consists of real blind, two relay outputs (up and down) to control the motor and two push button inputs to control level and angle of blinds.
doc_tap_basic_setup_blinds;
Go to the output module where the motors are physically connected, enable Blind under Blinds section. Choose the outputs for phase up and phase down for the motor control.
doc_tap_output_module_control;
|
|
|
|
|---|
To assign Control buttons to the blind, go to the input module where the push buttons are physically connected, find the right two inputs and enable them as Push buttons.
doc_tap_assign_Contorl_Push_buttons;
|
|
|
|
|---|
Go into Blind device details and add new Smart Rule "Control blinds with Up and Down" and select control buttons for direction Up and Down created in previous step.
doc_tap_Blind_device_step;
|
|
|
|
|---|
Now you have Blinds with manual control via physical push buttons.
doc_tap_have_Blinds_buttons;
In order to set durations for the blinds motors, please use Blinds configuration wizard
doc_tap_durations_wizard;